I need to mount the two uprights for the overhead hoist. I stopped at Fastenal yesterday and looked the Red Heads and then looked at Epoxy anchors. In the past when I've used or seen the Red heads used, a lot of time they do not grab right at the bottom as they are supposed to and you end up with an anchor not as deep as it should be. I've never used the Epoxy anchoring system before. I'm a few days away from putting the uprights up so I have a little time to decide.
Red Heads versus Epoxy Anchors, pros/cons? [Archive] - The Garage Journal Board
JavaScript must be enabled in order for you to use this site. However, it seems JavaScript is either disabled or not supported by your browser. Enable JavaScript by changing your browser options, and then try again. Please upgrade your browser or contact your System Administrator for support. Alternate products displayed below may not be identical in style or function to original selection. This item has been restricted from sale in the following states: PR.
OEM heavy duty through bolt stainless steel redhead epoxy anchors rapid bonding glue. Note: Based on continuous installation without interruptions or nozzle changes. Provided as a guide and will vary with temperature. Good Use Hardware Co.